Install RAM Memory and Mount a Motherboard For Your Custom PC Build

October 29, 2010 Computer Tips And Tricks

It is now time to get to some information with regard to the motherboard. You will need to get the motherboard actually installed onto the case as well as the factor that you will need to get to the core of the build. It is now time to install the RAM memory.

Before Installing RAM Memory

The truth of the matter is that installing the RAM is one of the easiest steps with regard to custom pc building. You do need to install the RAM module correctl. You also need to make sure that you install it in the right slot. These are some of the steps for installing RAM memory, I hope that this help you.

Depending on how much RAM, and how many RAM modules you want to install may play a role in what slots to use on the motherboard. For example, if you purchased (2) RAM modules, each 2GB, and your motherboard has four total RAM slots, you will likely need to install these RAM modules into specific slots, so that they can run in dual channel mode. Alternatively, if you purchased (4) RAM modules, and your motherboard has four total RAM slots, it doesn’t matter what order you install them in.
Consult your motherboard manual to find the proper RAM slots to run dual channel or triple channel. There should be a clear indication of which slots should be used.
Any time your RAM module amount matches the amount of RAM slots on the motherboard, you can go ahead and install all RAM modules.

Installing RAM Memory

Push to release the levers on each RAM slot. There should be a small lever on each side of the slot, where the RAM module will be placed.
(Important) Line up the RAM module with the pattern on the slot. RAM modules can only be installed one way. You may notice that the insert side of the RAM module has different lengths of contact area, which are separated by small gaps. Assure that your RAM module placement is consistent with that of the motherboard slots.

Line up and insert the RAM module on the according RAM slot on the motherboard. Using a steady, even pressure push the RAM module into the slot until it is all the way down. Almost all of the time, you will hear a confirmation click once the RAM has been installed fully into the motherboard, and each of the clips should snap back into place. However, you may need to insert the RAM first, and manually relock the clips.
Repeat the steps above to install any additional RAM memory modules.

Mounting the Motherboard

With the side panel removed, and the case open, locate the mounting holes for the motherboard. Normally, motherboards use 4-5 screws to be secured to a case. Thus, look for 4-5 holes.

There may be several holes in the case, so you may need to hover the motherboard over the case and look for the according correct mounting positions. Usually, there are mounting holes in each corner of the motherboard which should apply to four equally spaced mounting holes in the case.

Once located, insert a threaded spacer into each one of the motherboard mounting holes.

Gently, maneuver the motherboard into the case and place it on top of the spacers. Remember, each spacer should be aligned with an according mounting hole in the motherboard.
Once you have the motherboard properly and evenly seated, go ahead and insert the screws and fasten it in place.

I sincerely hope that this has helped you on many ways and that you understand how to do this.